What should I do if my high-speed punch press malfunctions?

   The more common faults are:
   1. The inching or linkage of the high-speed punch press can't run for some reasons, which makes the punch press can't stop in time;
   2. The red light of the second degree drop will not be dark, and it is always on;

High Speed Punching Machine

   3. The press can not automatically adjust the electric slider;
   4. The counter does not work properly and so on.

High Speed Punching Machine

　 The following are mainly about the reasons for the first two failures and the solution to these two failures.
　  First of all, the high-speed punch press inching or linkage for some reasons can not run, resulting in its inability to run for a variety of reasons. The first point is that the button switch of the punch press has a fault when switching, then just replace the bad switch on the line. The second point is the high-speed punch press line off or broken, resulting in punch press line failure, this time to remove the damaged line, replace the new line can be. The third point is that the PC control input of the punch press is abnormal, which means that the PC controller of the high-speed punch press fails, it is necessary to find professional maintenance personnel to detect the PC controller and repair it.

High Speed Punching Machine

　   Then the cause of the second drop red light will not be dark, has been on the reason is the punch press clutch and brake clearance is too large, not adjusted back, which will lead to brake time extension and angle shift, then as long as reference to the clutch and brake adjustment method to adjust the gap back on it; it may also be the cause of the punch press there is an overload, then the second drop red light will be ineffective, and will even make the punch press Stop working.
　  In the use of high-speed punching machine, if a failure occurs, first of all do not be anxious, to first find out the cause of the failure, in the cause of the symptomatic medicine, can be easily solved.