What are the modes of operation of a high-speed press?

    The operation modes of the high-speed press machine mainly include the following:

    Manual mode: It is used for assembling and adjusting the moulds as well as test punching to ensure that the moulds are installed correctly and the clearance is suitable.
    Inching Mode: Press the operation twist, the press will start to run, and the press will stop immediately when it is released, which is suitable for precise control of the stamping position.

    High-speed press machine operation mode


    One Stroke Mode: Pressing the operating button and then releasing it, the slider stops at the upper dead point after completing one up and down stroke, suitable for single stamping.
    Continuous operation mode: The slide moves up and down continuously, which is used for automatic feeding operation and continuous mass stamping production.

    High-speed press machine operation mode

     In addition, when operating the high-speed stamping press, the workers need to be professionally trained, familiar with the operating procedures and strictly abide by the safety operation norms, such as the correct use of safety protection and control devices, and checking from time to time whether the various parts of the equipment are normal or not.
    The above content is for reference only, the specific operation may vary depending on the equipment model and manufacturer, please refer to the equipment manual for operation.

    High-speed press machine operation mode