What is the problem that the punch press suddenly won't start?

     In fact, stamping is not as dangerous as imagined, but whenever there is a stamping injury, there are reasons. On the one hand, it is the reason of factory management, on the other hand, it is the reason of workers' operation. As long as you do a good job in both aspects, stamping is still very safe. Today through our ten years of stamping experience for you to analyze how to eliminate the danger of stamping.
    First, the factory should pay attention to matters
In fact, stamping can be viewed as logistics, the boss to provide cars for drivers to drive, at least to provide drivers with a fully qualified car. Stamping is the same, let the workers operate the punch press, if even the punch press can not guarantee complete qualification, safety and where to start? Equipment mainly has the following requirements:

    heat dissipation plate high-speed stamping machine

    1, good operation of the punch press
Good punching machine is the root of safe production, punching machine lubrication must be normal; copper tile can not appear excessive wear; brake tension to normal range; clutch, control system operation is flexible; all parts of the bolt can not appear loose.
   2、Installation of safety grating
After installing the safety grating, if the pressman's hand or other objects affecting safety enter the dangerous area, the press will be shut down in an emergency; in the shutdown state, the press cannot be started.

  3、Reasonable switch design
It is necessary to design two start switches and one emergency stop switch, and these two start switches must be at a certain distance from each other, as long as the pressman presses the two start switches at the same time in order to start the machine; the emergency stop switch can not be too far away from the pressman, otherwise, when a situation occurs, the workers can not be the first time to stop the press.

   heat dissipation plate high-speed stamping machine

  4、Reasonable design of stamping mold
If the press is the first element of safe production, the stamping mold is the second element. The production of stamping parts relies on the stamping mold, so whether the stamping mold design is reasonable plays a vital role in safety.
   5, must use safety tools
In the stamping process is absolutely not allowed to make the hand into the mold work area, which requires that must be a safety tool to complete the discharge and the work of the material. Now often used safety tools are magnet type, suction cup type and tweezers.
   6, reasonable noise reduction measures
Long time under the influence of the noise of the press, the concentration and mental state of the workers will continue to decline, reasonable noise reduction measures can not only ensure that the mental state of the stamping workers or the workers are responsible for the health!
    7、Establishing safety management system and press operation manuals
Stamping factory must not regularly on the stamping workers safety training, so that the concept of safe production in the hearts of the people. Help stamping workers to establish safe operating habits.

    heat dissipation plate high-speed stamping machine