Punch feeder step test method

    The punch press feeder step test method mainly includes the following steps:

    Basic test:
        Use inching operation to stop the punch press at the lower dead centre position, mark the material, and then make a single press and repeat several times to measure the feeder step distance.

   Punch Feeder Steps

    Accurate Comparison:
        Inching operation of the press to ensure that the press is punching against the guide hole and then comparing the position of the guide pin and the guide hole to verify the step setting.

 Punch Feeder Steps

    Multiple Feed Test:
        Adjust the feed step distance, stamp the material several times in succession, mark the material and check the position gap after several feeds to determine the feeding accuracy.

    Punch Feeder Steps

Mould installation test:
        After installing the mould, carry out feeding several times to check whether the product meets the accuracy requirement, in order to comprehensively determine the matching degree between the feeder and the mould. Detailed test steps and precautions are provided to ensure the accuracy and stability of the punching feeder step.