Installation and debugging methods of high-speed press moulds

    The installation and debugging method of high-speed punch press mould mainly includes the following steps:
   Preparation before installation:
    Check the mould: make sure that the edge of the mould is sharp, without chipping or missing corners, otherwise it is necessary to sharpen the cutter first 12.
    Clean the mould: use oil stone to grind off the burrs on the bottom and top of the mould, and clean it with cloth 12.

High-speed punch press moul

  Installation steps:
    Close the mould to protect: pad in silicon steel sheet between the upper and lower moulds to prevent the handling process from touching the cutter 12.
    Adjust the slider: adjust the travel of the slider to a suitable position, press the upper mould to ensure that the upper plane of the mould shank or the mould holder and the bottom surface of the slider are closely fitted 12.
    Remove the silicon steel sheet: Adjust the slider upwards, remove the silicon steel sheet, and then adjust the lower mould platen screws 12.
    Final check: raise the slider to the dead position, adjust the punch press beater bar stop screw, idle a few times to observe whether the mould and the various mechanisms of the punch press work properly12.

High-speed punch press mould

Debugging steps:
    According to the amount of distance between the hole of the material belt and the pin hole of the mould, adjust the feeder so that the material belt is fed into the mould smoothly for continuous debugging3.
   Through the above steps, you can ensure the correct installation and effective debugging of the high-speed punch press moulds for the subsequent production operations to provide protection!

High-speed punch press mould