OREKU high-speed press machine for you to explain the high-speed press machine mold setup stepsHigh-speed punch press frame mold steps are mainly divided into three steps: First, before the high-spee

High-speed punch press frame mold steps are mainly divided into three steps:

First, before the high-speed punch press rack mold:
① Select the appropriate die tonnage of high-speed press, check whether the die height is within the permissible range of the press.
② high-speed punch press under the table surface should be cleaned up, there shall be no foreign objects, mold under the mold seat bottom surface shall be no debris, to be put flat.
③ The mold should be placed in the middle of the punch press table.
④ Punching machine stroke selection inch movement.

High Speed Punching Machine

Second, high-speed punch press frame mold:
① press the mold should be the first rise slider, and then slowly lowered to the lower dead center by inching.
② mold with die handle, the die handle must be aligned with the die handle hole, to the lower dead center, close the first shrinkage of the lower die.
③ Molds without mold handle, place the mold in a suitable position, and note that the molds with drop holes must not block the drop holes.
④ The pads used must be flat, and must be checked to see if the force is balanced, and take care not to block the material to prevent the mold from being damaged by blocking.
⑤ The moldable die should firstly shrink the upper die, then put in the waste material of the required punching thickness, use the slider to adjust to the proper closing height, and empty it for two to three times, then lock the lower die.
⑥ V-type mold frame when the upper and lower mold slider will be closed to lock the mold, the slider will be raised by punching the material thickness of the size.

High Speed Punching Machine

Third, after the high-speed punch press frame mold:
① Check the upper and lower mold locking.
② check whether the upper and lower mold abnormalities.
③ tools in place, clean up the scene.

High Speed Punching Machine