Conductive Brackets are suitable for stamping with high-speed press machines? Can high-speed press machines produce Blade Fuse Block and Fuse Clip?

Conductive Brackets are suitable for stamping with high-speed press machines? Can high-speed press machines produce Blade Fuse Block and Fuse Clip?

Question: Conductive Brackets are suitable for stamping with high-speed press machines? Can high-speed press machines produce Blade Fuse Block and Fuse Clip?

Answer: Blade Fuse Block and Fuse Clip are like this (as shown below)

High-speed press machines can be used for high-speed production, 

and the stamping speed can reach about 250-400 times per minute. 

The stamping efficiency is subject to actual production, 

because the production effect of Blade Fuse Block and Fuse Clip depends on the mold design of Conductive Brackets. 

If the Conductive Brackets mold design produces 5 Conductive Brackets or Blade Fuse Block and Fuse Clip in one stamping. 

Then the production efficiency will be very high.